Corrigendum of the Assembly Guide

The assembly guide is a very important document for building the OpenVario. Unfortunately there are some fotos of prototypes included, which differ in some details from the current version. To avoid confusion for the builders, here is an overview about the wrong or outdated pictures:

3.3 V regulator in wrong orientation:

The Openvario Assembly Guide.pdf has several fotos with wrong oriented 3.3 V requlator (IC 1 TS2940) on the adapterboard. The Fig. No. 13, 14, 15, 17, 19, 24, 33, 37 are affected.

UART-cable rotated

In the same document, the UART-cable between Cubieboard and Adapterboard is rotated. This can be seen in Fig. 18 and Fig. 19. The OpenVario will not boot if the UART0-cable is rotated. Exchange RX and TX in this case.

Go to the Setup Guide

Go to the Errata

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies